WorldViz User Forum  

Go Back   WorldViz User Forum > Plug-in development

Thread Tools Rate Thread Display Modes
Old 09-20-2012, 01:22 PM
manueleh manueleh is offline
Join Date: Sep 2012
Posts: 3
How to create AMTI AccuGait force plate plug-in using serial port connection?

Hello everyone,

I am new to vizard and python, but was looking to use an AMTI AccuGait force plate over a serial port connection to read in forces and moments.

I have tried the pySerial module, as mentioned in prior threads, but I can't figure out how to send the necessary start command (i.e., a 0x51 hex value) to the force plate to start receiving data.

Would any of you have any suggestions? or prior experience with this force plate?

Thank you all so much!
Reply With Quote

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Question about serial port mizutani_jun Plug-in development 6 11-21-2010 03:53 PM

All times are GMT -7. The time now is 02:48 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 2002-2023 WorldViz LLC