connecting to SMI iViewX running a RED tracker

[pkhoosh]

I added those lines and am now outputting the same thing that I was getting with the while loop.

Namely,

[0.0, 1023.0, 0.0]
Calibration size: (1280,1024)
....
[0.0, 1023.0, 0.0]
Calibration size: (1280,1024)

Again, I'm not getting any errors when adding the SMI.dle

[farshizzo]

Does the iView program show that the gaze position is changing? It appears Vizard is connecting properly to the iView program since it is receiving a valid calibration size. So if the position is not changing within Vizard, then either iView is sending the same data values or not sending any data values at all.

[pkhoosh]

Yes, iView shows changing position.