connecting to SMI iViewX running a RED tracker

[Jeff]

Can you post an example script you've tested with?

Are you getting the data within the SMI Experiment Center?

Do you have any firewalls/virus scanners enabled?

[pkhoosh]

I am using Experiment Center to collect the data, but it is actually getting the raw eye data from the dedicated laptop running iView.

I have everything (iView laptop, Experiment Center desktop, Biopac, and Biopac recording laptop) running through a network switch and they are all communicating fine so there's no firewall issue.

# data aggregation of Eye tracking from SMI and synching with Biopac recording channels

smi = viz.add('smi.dle')

tracker = smi.addEyeTracker(address='192.168.10.1', port=4444)

while 1:
	print tracker.getPosition(smi.PIXELS)	
	print 'Calibration size:',tracker.getCalibrationSize() 
end

[Jeff]

Are your results any different if you get the data in a timer function?

def showData():
	print tracker.getPosition(smi.PIXELS)	
	print 'Calibration size:',tracker.getCalibrationSize() 
	
vizact.ontimer(0,showData)

[farshizzo]

Does your script output any error messages when adding the eye tracker? What version if iView X are you running? The plugin is based on the the network protocol defined in version 2.1.14.