How to set the viewpoint as the proximity target in a Vizconnect configuration? - WorldViz User Forum

		WorldViz User Forum > Vizard
How to set the viewpoint as the proximity target in a Vizconnect configuration?

Thread Tools

Rate Thread

Display Modes

06-01-2015, 11:18 AM

Jeff

WorldViz Team Member

Join Date: Aug 2008

Posts: 2,471

Use the following to get a handle to a node3D object that has the same transform as the viewpoint:

Code:

viewTransform = vizconnect.getDisplay().getNode3d()
target = vizproximity.Target(viewTransform)

This is a linkable object that provides position and orientation but it's not a direct handle to the viewpoint. So it can't be used to set the viewpoint position.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Proximity Sensing Using Kinect	JamesCakes	Vizard	6	06-24-2016 05:52 AM
Orientation selective (Viewing Vector) Proximity Sensor	lmGehrke	Vizard	2	03-17-2015 12:31 PM
Switching between input devices setup in vizconnect and not using vizconnect	JB_HP_Viz	Vizard	1	01-20-2015 05:19 AM
vizproximity hint - debug 2D areas related to a source only after adding a target!	fordprefect	Vizard	1	12-15-2014 12:37 PM
Avatar w/ hat cannot look at viewpoint	TrashcanPatrol	Vizard	5	08-19-2008 08:26 AM

All times are GMT -7. The time now is 08:03 AM.