|
|
#4
03-23-2014, 09:37 PM
|
|||
|
|||
|
What is the version number of FAAST that you are using?
I'm wondering if all the other tracked objects are off by the same amount. If so, you could do an initial calibration where the user's highest tracked object (head) and the lowest tracked object (foot) are visible to FAAST, and then figure out the difference. That should provide a loose approximation of the user's height. I'm not sure whether or not this would be accurate enough for your application. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cal3d skeleton exporter error | pwsnow | Vizard | 0 | 07-23-2013 10:15 AM |
| Kinect auto selection of skeleton | victorqx | Vizard | 0 | 05-29-2012 09:30 AM |
| Head Height | Plymouth | Vizard | 5 | 02-12-2007 11:38 AM |
| female skeleton CSF file needed to export to CAF format | vmonkey | Vizard | 1 | 10-04-2005 11:15 AM |
| Constraining Height | nickyee | Vizard | 7 | 01-18-2005 02:46 PM |
Threaded Mode