restart plugin within script?
I am using an Inertiacube which works fine for about 2 minutes, but then
the orientation data begin to lag the motion by approximately 0.5 sec. If I stop and restart the script the Inertiacube starts out fine again but then develops the delay. Is there some way that I can unload and then reload the intersense plugin while the program is running instead of stopping and restarting the script? Or any ideas about how to eliminate the lag once it begins? Sort of like flushing the buffer. |
Make sure you are using the intersense.dle plug-in rather than the deprecated intersense.dls plug-in?
If you are than perhaps the cube is defective. Is the result the same with Intersense's software? |
All times are GMT -7. The time now is 11:45 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 2002-2023 WorldViz LLC