#1
|
|||
|
|||
restart plugin within script?
I am using an Inertiacube which works fine for about 2 minutes, but then
the orientation data begin to lag the motion by approximately 0.5 sec. If I stop and restart the script the Inertiacube starts out fine again but then develops the delay. Is there some way that I can unload and then reload the intersense plugin while the program is running instead of stopping and restarting the script? Or any ideas about how to eliminate the lag once it begins? Sort of like flushing the buffer. |
#2
|
|||
|
|||
Make sure you are using the intersense.dle plug-in rather than the deprecated intersense.dls plug-in?
If you are than perhaps the cube is defective. Is the result the same with Intersense's software? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating a Vizard Sensor Plugin | farshizzo | Plug-in development | 25 | 08-01-2019 12:24 AM |
Live Characters plugin | Frank Verberne | Vizard | 7 | 03-01-2012 02:23 AM |
Howto debug a custom plugin? | reedev | Plug-in development | 3 | 04-23-2009 02:16 PM |
Vicon Plugin | Micheal | Plug-in development | 2 | 08-29-2007 03:03 AM |
Could not find plugin to load objects... | halley | Vizard | 1 | 05-30-2006 11:01 AM |