|
#1
|
|||
|
|||
About vizproximity
When I add a sensor to a object, there will be a sensor like a frame outside the object.
Is there a method to get rid of the green frame like setting it to transparent or setting it only shows up when the mouse enter the sensor? Thanks |
#2
|
|||
|
|||
You can do something like:
Code:
manager.setDebug(viz.OFF) debugEventHandle = vizact.onkeydown('1',manager.setDebug,viz.TOGGLE) |
#3
|
|||
|
|||
thanks it works
|
#4
|
|||
|
|||
Hi haohaoxuexi1
You can also use the Proximity Events when the target(MainView or Grabbber or any object) enters the proximity ,the Outer box Debug can be set to OFF and when the target leaves the proximity area the debug can bet set to ON. def EnterProximity(e): if e.sensor==sensor1: manager.setDebug(viz.OFF) if e.sensor==sensor2: manager.setDebug(viz.OFF) #and so on def ExitProximity(e): if e.sensor==sensor1: manager.setDebug(viz.ON) if e.sensor==sensor2: manager.setDebug(viz.ON) #-----Registering sensors for proximity enter and exit evenst--------# manager.onEnter(None,EnterProximity) manager.onExit(None,ExitProximity) Thanx & reagrds Mr.Rajnish Vishwakarma Software Developer for Mobile,AR,VR |
#5
|
|||
|
|||
Quote:
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
vizproximity hint - debug 2D areas related to a source only after adding a target! | fordprefect | Vizard | 1 | 12-15-2014 12:37 PM |
wait for vizproximity and waitKeyDown in task | krimble | Vizard | 2 | 08-14-2013 03:14 AM |
Vizproximity questions. | nabrahamson | Vizard | 3 | 04-04-2012 04:59 PM |