#1
|
|||
|
|||
Reset to starting position when using Vizconnect
If I have a configuration like below and I would like to setup a way to remember the starting position and then be able to reset to that starting location if I move around.
So if I hit Key '1' and move around using keyboard and then I hit Key '2' and I fly around using Mouse/Keyboard. What is the code to reset to the starting position? Code:
display = vizconnect.getDisplay() keyTracker = vizconnect.getTracker('keyboard') fly_mouseKeyTracker = vizconnect.getTracker('mouse_and_keyboard_flying') vizact.onkeydown('1',display.setParent(keyTracker)) vizact.onkeydown('2',display.setParent(fly_mouseKeyTracker)) John |
#2
|
|||
|
|||
I'll respond here with example code early next week.
|
#3
|
|||
|
|||
Sounds good.
Thank you |
#4
|
|||
|
|||
Attached is an example that illustrates the use of viewpoints with
vizconnect. You can reset the vizconnect viewpoint to a specified location. |
#5
|
|||
|
|||
The example works great.
Thank you. |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Switching between input devices setup in vizconnect and not using vizconnect | JB_HP_Viz | Vizard | 1 | 01-20-2015 06:19 AM |
Changing parent without changing absolute global position? | The SundanceKid | Vizard | 2 | 05-23-2014 03:43 PM |
Getting updated position | Anastaggra | Vizard | 1 | 02-01-2014 01:15 AM |
Mouse event: how to detect no mouse move event, how to set mouse position? | Zhi | Vizard | 3 | 04-11-2011 07:25 PM |
default start position | erchrastil | Vizard | 2 | 06-23-2008 09:15 AM |