#1
|
|||
|
|||
Level of Detail ranges from Max OSG exporter
I think I've finally to figure out how to get my Level of Detail models into Vizard (I think)
I'm having problems with the ranges that you can set for each in Max. Is there some sort of unit conversion that someone can explain? I'm using 3 models, and I've determined that a range of 0-100 is too small and 0-1000 is to large. I've played around with it, but can't seem to get good ranges by trial and error. |
#2
|
|||
|
|||
The LOD ranges should represent distance to the viewpoint. The range units should match whatever units you are using in 3dsmax. If you think it's still not correct, can you provide us with the max model?
|
#3
|
|||
|
|||
Ah, I think I may have it. We were scaling the model WAY down when bringing it into vizard so I think that was messing with the LoD ranges. I scaled it down, then exported it and I think it's working better.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rendering level | shahramy | Vizard | 1 | 07-26-2010 12:12 PM |
Level of Detail | envisC | Vizard | 2 | 10-22-2009 12:07 PM |
Big problem with OpenSG exporter for max to Vizard | omadawn | Vizard | 5 | 06-09-2009 11:51 AM |
cal3d exporter | lqakane | Vizard | 0 | 03-02-2009 07:38 AM |
At my Whits end with Cal 3D Exporter | shivanangel | Vizard | 6 | 02-25-2007 03:00 PM |