|
#1
|
|||
|
|||
Monitor Modes & Vizard (problems...)
Hey,
So I'm trying to both get the most out of the awesome display setup I have (two 30" dell flat panels) and not break vizard. So far they've been mutually exclusive. Our system was set up with the monitor setup as: One monitor output (the left monitor output) going out at 2048 x 768 (two 1024x768 monitors concatenated). This was split into two 1024 x 768 displays, apparently by the HMD, and one of those went to left monitor. Right now, I have my left monitor set up as 1650 x 1050, which is it's native resolution. It looks beautiful. Unfortunately, Vizard does not come close to working. Through the HMD, I see nothing. One problem: 1650 x 1050 is, obviously, not a common resolution. So I just used NVidia's control panel to set it as a custom resolution. The default (double-wide) resolution did not use NVidia to do anything at all, I think. So... my question is...
Thanks for any help! I hate screwing this stuff up, but it's irritating to be wasting about 1/2 of my screen space all the time. |
#2
|
|||
|
|||
Hi tmcw,
I'm not sure I can help you directly, but we are also running a dual-monitor with HMD setup. The best way we've found to set it up (recommended by the vizard guys) is to unattach the secondary monitor in the Windows control panel, then set NVidia to Horizontal Span. This makes Windows think it's running a single doublewide monitor, but apparently it's more processor-efficient than setting two monitors. Vizard then (using viz.stereo) splits the image and sends one to each half of the "doublewide" monitor, or one to each physical monitor. Note that we have a dual-channel video card, and each monitor is still attached to its respective output. Also, we've noticed that our HMD (a Kaiser SR80A) can only handle its native resolution of 1280x1024; this may be why you're not getting any display in the HMD at higher resolution. Let me know if I can be of any more help! |
Thread Tools | |
Display Modes | Rate This Thread |
|
|