|
|
#1
03-24-2003, 10:55 AM
|
|||
|
|||
|
Inertia Cube
Hi,
I am using the PPT system with Vizard and the Intersense Inertia cube. I am having some troubles with Vizard and the Inertia cube. Sometimes Vizard does not seem to "attach" to the Inertia cube initially. Also, sometimes when I re-run a script within Vizard, the cube's signal is lost. When this happens I typically check whether the Intersense software is still receiving a signal and it is. When this happens I have to restart the computer to get it to recognize the cube. Is there something else that I can do? Brian Stankiewicz
__________________
-- Brian J. Stankiewicz, Ph.D. Department of Psychology & Center for Perceptual Systems University of Texas http://stankiewiczlab.psy.utexas.edu 
|
|
#2
03-24-2003, 12:00 PM
|
|||
|
|||
|
Hi Brian,
Are you running the Intersense software while running the Vizard script? You need to disable all Intersense software when using the InertiaCube with Vizard. Also, intersense automatically runs a program called "IServer" when your computer starts. This has been known to interfere with Vizard. If IServer is running on your computer then there will be a small blue icon in the lower right corner of the screen. To stop it, just right click on it and disable it. I hope this solves your problem. -- Farshid
|
 |
|
|
Linear Mode
