walkto plays no animation...

[k_iwan]

Hi,

I do apologise for making you running around in a circle. I did not explain the script fully. I tried to post the full code, but this forum refused it, being too lengthy. What I posted previously was a module of a bigger simulation program. You need to add viz.go() as well at the end of the program.

I do apologise.... T_T

You may use these following these commands (in the terminal window) to make them run...

controlAction()
stiltsAction(), and
stumpsAction()

..to make them run.

I just found the solution. I increased the spacing between the movement points and it works just fine. Apparently, my spacing between points were too small. I Increased the spacing and it works really well.

Thank you.

Kind Regards,
Iwan