Flock of Birds

[Atul Thakur]

The sample program cbird.exe is running fine. I mean, when i move the wanda, the coordinates change in case of cbird.exe <not yet calibrated it though>
However, in case of Vizard the coordinates do not change in one run.
But when I run the script in Vizard again after moving the wanda, the position is changed. This indicates that apparently there is no hardware problem.
I checked the Baud rate and dipswitch setting. As per the Ascension manual the settings are right.
thanks,
-Atul

[farshizzo]

Do you have an ERT (Extended Range Transmitter) connected?

[Atul Thakur]

Originally Posted by farshizzo

Do you have an ERT (Extended Range Transmitter) connected?

Apologies for my limited knowledge about the hardware. The transmitter that I have, seems to be the standard one. Its not an ERT. The transmitter is connected properly.
is this what you wanted to know?
-Atul

[farshizzo]

The ERT is a really huge, heavy, black transmitter. You would definitely know what it is if you had one

I just tested your script here and it works fine for me. Can you verify that you are using the following dip switch settings:

1 - down
2 - up
3 - down
4 - up
5 - up
6 - up
7 - up
8 - up

[Atul Thakur]

Originally Posted by farshizzo

The ERT is a really huge, heavy, black transmitter. You would definitely know what it is if you had one

I just tested your script here and it works fine for me. Can you verify that you are using the following dip switch settings:

1 - down
2 - up
3 - down
4 - up
5 - up
6 - up
7 - up
8 - up

It works now!!
My dip switch setting earlier was 10100010. I changed it to 10100000 as you said. And now it works fine for me.
Thank you very much,

-Atul