SenSable Open Haptics/Vizard SensAble Plugin

[farshizzo]

This seems to indicate that the 32-bit OpenHaptics 3.0 binaries (i.e. hd.dll and hl.dll) were not installed properly. Even if you are running on a 64-bit system, you still need the 32-bit binaries, since Vizard is a 32-bit application.

You might need to double check with SensAble to make sure their 64-bit installer still supports 32-bit applications.

[mhead10]

To make a long story short, I finally found using the newest driver from SensAble's website (4.2.133) instead of what comes packaged with Open Haptics 3.0 (4.2) fixed my problem.

Thanks for your help farshizzo

[mhead10]

If I'm now using two devices, how do I determine what the names are?

For instance, previously I could use one device with the following code:

device = sensable.addHapticDevice()

However, now I'm using two devices, and thus need to figure out what their names are. Therefore, how do you determine the names? Where are the names assigned? Is this a guess and check method?

I have tried, Left, Right, left, right, 1,2, and 3 and unfortunately I cannot connect.

Thanks