Hey,
So I'm trying to both get the most out of the awesome display setup I have (two 30" dell flat panels) and not break vizard. So far they've been mutually exclusive.
Our system was set up with the monitor setup as:
One monitor output (the left monitor output) going out at 2048 x 768 (two 1024x768 monitors concatenated).
This was split into two 1024 x 768 displays, apparently by the HMD, and one of those went to left monitor.
Right now, I have my left monitor set up as 1650 x 1050, which is it's native resolution. It looks beautiful. Unfortunately, Vizard does not come close to working. Through the HMD, I see nothing.
One problem: 1650 x 1050 is, obviously, not a common resolution. So I just used NVidia's control panel to set it as a custom resolution. The default (double-wide) resolution did not use NVidia to do anything at all, I think.
So... my question is...
- Can I fix this and go back to what I had before?
- Can I somehow have a nice dual-monitor (1650 x 1050 x 2) mode, and also switch back to the double-wide mode before running viz?
- How should this be set up, anyway? For whatever reason, both monitor outputs are going to the HMD even though the left one is the double-wide one? Is Vizard switching resolutions when it runs a simulation? Does the right output contribute anything at all?
- Another quandry is that my dual-monitor options seem to have disappeared. This might be because it isn't directly connected to the second monitor.
Thanks for any help! I hate screwing this stuff up, but it's irritating to be wasting about 1/2 of my screen space all the time.