Hi,
I just got an Intersense InertiaCube2 for use with Vizard, and as soon as I installed the Intersense software, I got it to work with the scaffold example, but when I restarted the computer it stopped working, even if I restarted again. Here is the error message:
ISENSE.DLL: Faile to create Shared Memory Interface to IServer. Please re-install software.
I reinstalled the software and that didn't change anything. The output is as follows:
Loading File: tut_ground.wrl
** ERROR: Failed to connect to intersense
InterSense Library ver. 3.80
Copyright 1998-2003 InterSense Inc.
http://www.intersense.com
Tel: 781-270-0090
Detected InterSense Server
intersense.dls Intersense Driver v2.0
Any advice will be greatly appreciated. Thank you,
Marco