Hello,
I am trying to set up a 2 camera PPT-X system and for some reason the cameras are not picking up the calibration rig.
I tried running this code
Code:
import viz
viz.go()
PORT_INTERSENSE = 3
isense = viz.add('intersense.dls')
but I get this output
Code:
******************************************************************************
** Loading Test.py
******************************************************************************
intersense.dls Intersense Driver v4.0.4
** ERROR: Failed to connect to intersense on port 3.
** Load Time: 3.11 seconds
(the next part pops up when I close the test window)
InterSense Library ver. 4.04 32-bit
Copyright 1998-2007 InterSense Inc.
http://www.intersense.com
Tel: 781-541-6330
Looking for InterSense tracking device number 1.
Please wait ...
InterSense tracker not present
I saw a previous thread that said to check the port, but I think port 3 is the correct one to listen from.
At one point one of the camera was detecting the calibration rig but now it just looks like this.
Thanks for the help!
-Karma