How to create AMTI AccuGait force plate plug-in using serial port connection?
Hello everyone,
I am new to vizard and python, but was looking to use an AMTI AccuGait force plate over a serial port connection to read in forces and moments. I have tried the pySerial module, as mentioned in prior threads, but I can't figure out how to send the necessary start command (i.e., a 0x51 hex value) to the force plate to start receiving data. Would any of you have any suggestions? or prior experience with this force plate? Thank you all so much! -Manuel |
All times are GMT -7. The time now is 02:03 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 2002-2023 WorldViz LLC