Inertia Cube 3 Wireless
 

I am using Inertia Cube 3 Wireless, connected to USB. How do I setup the usb ports? I have already connected 5DT gloves using
PORT_5DT_USB = 0
PORT_5DT_USB = 1
Is there a similar tag for Inertia Cube? Do I continue the numbering?

The intersense driver will assign a virtual port number to the wireless IC3. So you use the standard PORT_INTERSENSE flag to connect to it. You can use the DeviceTool program that comes with the Intersense drivers to find out what the virtual port number is.

I am using the scaffold.py to test the Intersense IC3
The DeviceTool showed port 3 in use so I added
PORT_INTERSENSE = 3
in the global section.
Still the message comes out:
** ERROR: Failed to connect to intersense on port 3.

Any ideas?

That should work, so I don't know what is going on. Is the InterSense Server program able to connect to the IC3 on port 3?

Found the problem! While devicetool is running other programs cannot access the device! I thought that it only happened with the server. That simple...