WorldViz User Forum

WorldViz User Forum (https://forum.worldviz.com/index.php)
-   Plug-in development (https://forum.worldviz.com/forumdisplay.php?f=8)
-   -   How to create AMTI AccuGait force plate plug-in using serial port connection? (https://forum.worldviz.com/showthread.php?t=4366)

manueleh 09-20-2012 01:22 PM

How to create AMTI AccuGait force plate plug-in using serial port connection?
 
Hello everyone,

I am new to vizard and python, but was looking to use an AMTI AccuGait force plate over a serial port connection to read in forces and moments.

I have tried the pySerial module, as mentioned in prior threads, but I can't figure out how to send the necessary start command (i.e., a 0x51 hex value) to the force plate to start receiving data.

Would any of you have any suggestions? or prior experience with this force plate?

Thank you all so much!
-Manuel


All times are GMT -7. The time now is 06:01 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2002-2018 WorldViz LLC