Y Position different than 3.0
Hi All,
Did anybody experience any differences in Y positioning when going from Vizard 3.0 to 4.0? We are using an intersense I-900, and although the position outputs the same, the viewpoint seems to be a couple of meters lower in the few scripts I have tested so far. I have tried experimenting with the eyeheight but it doesn't seem to change anything. It only happens when tracking is enabled. Anybody have this issue? |
Are you linking the sensor to the viewpoint? In 3.0, the eyeheight would be added to the Y value of the link source, unless the viz.LINK_POS_RAW flag was used. In Vizard 4.0, this is not the case and the eyeheight is ignored when linking.
|
I was linking and that seems to be the issue. Would the best way to modify old scripts be a postTrans on the link position, adding default eyeheight to the Y position?
|
Yes, you can use either the postTrans or setOffset commands to add an offset to the Y position.
|
All times are GMT -7. The time now is 03:26 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 2002-2023 WorldViz LLC