WorldViz User Forum

WorldViz User Forum (https://forum.worldviz.com/index.php)
-   Vizard (https://forum.worldviz.com/forumdisplay.php?f=17)
-   -   Intersense won't work with a USB joystick (https://forum.worldviz.com/showthread.php?t=573)

Vbents 05-04-2006 08:59 PM

Intersense won't work with a USB joystick
 
Hi,

We recently installed a new computer with Vizard 2.53, and now I am unable to use both my USB joystick (a Logitech WingMan rumblepad) and the orientation sensor (an InertiaCube2). In fact Vizard crashes when I add the line: viz.add('intersense.dls'). However, the USB mouse and keyboard do not have any effect.

There was an earlier thread that commented on this problem, but it didn't give any solution, and since this was not a problem before with essentially the same hardware and software, I was hoping someone knows what is going wrong here.

Thanks,
Ben

mspusch 05-04-2006 10:24 PM

From all I know, this is due to a new version of the Intersense driver after they came out with their USB devices, and is pretty much more or less an Intersense bug.

However, there is a workaround that works very well which is to specify the port the Intersense is connected to (you can look it up under windows device manager under com-ports ).

What you do in Vizard is to specify the exact port the InertiaCube is connected to by placing the command

PORT_INTERSENSE = 3 #in case the InertiaCube is connected to COM port 3

right in the line in front of initiallizing the Intersense device

orientation = viz.add('intersense.dls')

so the total code for adding an InertiaCube2 then reads as


PORT_INTERSENSE = 3 #in case the InertiaCube is connected to COM port 3
orientation = viz.add('intersense.dls')


All times are GMT -7. The time now is 07:16 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Copyright 2002-2018 WorldViz LLC