Flock of Birds
Hi,
I am new to this community. I am using Flock of Birds (FOB=1). Following is the simple scripts I am trying PHP Code:
However, if I run the script again, I get the new coordinates Not sure what is the mistake in the code, I am making. Someone, kindly help. -Atul |
Do you get the same problem with the sample program that comes with the Flock of Birds, or does it only happen in Vizard? I remember having a similar problem before and I had to reset the Flock of Birds device to get it working again. Also, make sure you have the correct dip switch settings for the specified baud rate and number of birds you are using.
|
The sample program cbird.exe is running fine. I mean, when i move the wanda, the coordinates change in case of cbird.exe
However, in case of Vizard the coordinates do not change in one run. But when I run the script in Vizard again after moving the wanda, the position is changed. This indicates that apparently there is no hardware problem. I checked the Baud rate and dipswitch setting. As per the Ascension manual the settings are right. thanks, -Atul |
Do you have an ERT (Extended Range Transmitter) connected?
|
Quote:
is this what you wanted to know? -Atul |
The ERT is a really huge, heavy, black transmitter. You would definitely know what it is if you had one ;)
I just tested your script here and it works fine for me. Can you verify that you are using the following dip switch settings: 1 - down 2 - up 3 - down 4 - up 5 - up 6 - up 7 - up 8 - up |
Quote:
My dip switch setting earlier was 10100010. I changed it to 10100000 as you said. And now it works fine for me. Thank you very much, -Atul |
All times are GMT -7. The time now is 04:13 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright 2002-2023 WorldViz LLC