PDA

View Full Version : Oculus CV + PPT-E


Antti
09-27-2016, 07:28 AM
Hi,

We have had issues with bouncy positional tracking with Oculus Rift CV1 with PPT-E system for a couple of weeks now. Today I spent several hours trying to figure out where the problem lies and apparently it's the CV1.

I went through all of the HW configurations (camera adjustments, calibration, tuning, wand+eyes settings, etc) and everything worked fine.
Then after turning Oculus on the bouncing started once again. I removed and turned off the eyes and wand. That's when I realized that CV1 itself is emitting light that is tracked by PPT-E system, therefore causing bounciness in the positional tracking.

Do you have a quick solution for this? (Other than covering the oculus front and back plates with cloth :D )
I wasn't able to find anything quick myself, other than modifying oculus's .cs files...

Jeff
09-27-2016, 08:51 AM
Make sure the Oculus camera sensor is disconnected. That will activate the LEDs in the HMD.

Antti
09-28-2016, 01:44 AM
Hi Jeff,

I tried that yesterday and it didn't work. Today, however, it works as intended.

Thanks